Qlik View Access Point unable to load

[balajibc64]

Hi, I installed QlikView in my server. Once installed successfully I'm trying to open the access point but the page is not loading. Anyone help me on this?

1. Its based on IIS service. 

2. My QlikView QMC is working fine.

3. I checked the IIS service , .Net framework file everything is available and running. 

4. Also I'm the admin user. 

5. Added all the local and grup policies. 

But still the page is not getting loaded 😞

[Lucas_Gatling]

@balajibc64  Good morning. Please review the following KB article: https://community.qlik.com/t5/Official-Support-Articles/QlikView-Access-Point-not-loading-shows-a-bl...

Make sure you review the IIS specific part to make sure you have your IIS webserver configured correctly.

[balajibc64]

@Lucas_Gatling Thanks for you response. Already I reviewed the documents and follow the steps. but still facing the same issue. 

[Chip_Matejowsky · Accepted solution]

Hi @balajibc64,

Have a look at Qlik KB How to Configure:  QlikView and IIS, paying particular attention to the Prerequisites section and the What to Check section.

Best Regards