Filter and button select data display on table in Qlik Sense

[sat_tok52]

Hi All,

I have a Country filter and View Report Button in my dashboard. First the user select the country filter then  click on View Report button after that the table data should display . I used below logic its not working .Any help.

Getselectedcount(Country)>0 and $(vShow)=1

Thanks.

[GaryGiles]

Your logic looks fine.  Where are you using it and are you sure that the vShow variable is getting set properly by your Action button?

[sat_tok52]

Hi Gary,

Thanks for your response. Yes the logic is fine but my current  button is working like on and off mode. As per my requirement user selected country in country filter pane and just click on View report button the data display in the table. Without any selection it show message on the table. But my current button is working like show and hide ,once I select the filter and click on view report button it display as expected, but again I need to click button to hide the data ,it's not like that. Once user select filter and click on view report button just display data ,if click on clear all selections  again he select the filter and click on button just display data on table.

Getselectedcount(Country)>0 and $(vShow)=1

Thanks,